Global Wood |
Trade Lead |
Posted Time:7/3/2019
Type: Sell |
|
| Subject: | Wooden Poles for electricity |
| Details: | Hello, I have 2 demands: - 20 000 pcs of 12m the main one and also - 50 000 pcs of 9 m More detail : The Tenderer is required to state in the offer the Supplier?? experience in the fabrication and supply of the wood poles they have proposed. In particular the Tenderer shall state: A: in case the tenderer is the producer he must prove that the sold quantities of wood poles for the last two years are not less than (30000) ( ??12 m) poles. B-in case the tenderer is not the producer , he must prove that the quantity of poles he has sold for the last five years are not less than (50000) poles( ??12 m) poles and producer must prove what mentioned in item A. The sold quantities for item A and B must be in detail as follow: Quality assurance The tenderer is required to describe in the offer the applied manufacturing quality assurance (QA) procedures and to submit accredited independent QA verification certification where these are available. PEDE reserve the right to inspect the tenderer's manufacturing facility to undertake a QA audit during the period of tender evaluation. Applicable Standards ? For Wood Poles: BS 1990-part- 1 ( U.K ) EN 12509 . Timber pole for over head line .Test method. Determination of elasticity bending strength. density and moisture contents . EN 12510 EN511 NF - C67 -100 : Supports for overhead lines wood poles ??specifications ( FRANCE ) ? For Defects: ANSI . O5 . 1: American national standard for wood poles - specification and dimension ( U.S.A ) ? For Creosotes Specifications: BS 144 : Specification for coal tar creosote For wood preservation. ( U.K. ) EN 13991 2003 ? For Preservation Treatment: BS 913 : Specification for wood preservation ( U.K. ) BS 8417: 2003 Site Climatic Conditions The climatic conditions in which the poles will be situated shall be assumed to be as follows: 1. General system climatic data Maximum site ambient temperature ?C 55 Minimum site ambient temperature ?C -10 Maximum site relative humidity at 30?C % 80 Site altitude m < 2000 Maximum site solar radiation W/m? 1100 Timber Species The species of timber to be used for the poles shall be PINE grown in northern latitudes (45) and above .. The poles shall be straight, sound, hard grown, free from large or dead knots or other defects and shall have the outer and under bark completely removed. Trees grown in Northern Europe shall have been felled not earlier than 1st November and not later than 31st March and all trees shall have been felled when the sap is down. The trees shall be sawn off as close to the ground as possible and not timber shall be removed, trimmed or cut from the butt end so as to reduce its natural size. The ends shall be sawn to give a flat section and branches shall be dressed down flush with the trunk. Bark shall be removed as soon as practicable after felling and the poles shall then either be stacked in open formation clear of the ground or stored in water that is free from marine borer activity. Regards Miguel Couto From Celtic Timber whatsapps +33 6 64 76 21 54.. |
| Contact Address | |
| Name: | miguel couto |
| Position: | |
| Company: | celtic timber trading |
| Email: | Request For Quote |
| Tel.: | +33664762154 |
| Fax: | |
| Homepage: | http:// |
| Address: | rue de la butte |
| City: | Jouars Pontchartrain |
| Province: | Not Applicable |
| Country or Area: | France |
| Postcode: | 78760 |
